What's Wrong with My Puffco Peak? Use your fingers or a pry tool to peel the metal disc off of the bottom of the plastic Puffco Peak base. Once the silicone boot is loose the the bottom, pry upwards from below the USB port and remove the silicone sort of like a sock, where the atomizer connection is the toe. Step 3: Remove the Silicone Boot. I still have some detective work to do to determine why my Puffco Peak doesn't charge. Be careful and go slow. If it feels stuck, apply a small amount of heat and try again.
The bucket rests directly atop the heating element – extract can glue it in place – and tugging on the element can damage it's fragile connecting wires. Unscrew the metal housing for the heater by turning it counter clockwise several times to disengage the threads. Ideally, finding out which component has failed; and swapping it for a working one is best – but my electronics skills are limited. I suspect that there is an onboard boost converter that steps USB voltage up to above 7v, and it is defective. Using your thumbs, press outwards from the center on the base of the Puffco Peak.
Step 6: Open and Inspect. When removed however, the battery is completely dead and the Puffco shows no signs of life. I was told, "It doesn't charge – it's broken. The teardown video is up on Youtube now: Step by Step Instructions: How to Open a Puffco Peak. Begin the disassembly process by removing the atomizer, bucket, and surrounding components. It's only on USB power that the device fails to charge. If that isn't the case, I'll be adding an external battery pack to make up for the lack of internal charge circuit. This is the most confusing part of this disassembly, and I suggest you watch the video starting from about the 1:00 minute mark for a video example.
The silicone will lift out from under the shiny metal base of the Puffco. We're starting off with a standard Puffco Peak base – glass removed. If anyone has input, questions or ideas – I would love to hear them in the comments below or on the Youtube video linked above. 5v to the battery connection leads – the battery charges and holds its charge. It will lift off, and may require a twisting motion or a small amount of heat if it feels stuck. These devices are simple, and with that in mind; there shouldn't be too many ways for the device to fail. Note: In my video, I perform step 5 before step 4 – and it really doesn't matter in the end, but I feel it's easier in this order. The adhesive is fairly strong, and so some force is required to remove this piece. It may help to warm this area with a hair dryer or gently using a heat gun. If you have done this before it makes sense, otherwise: read on. One of these screws is below a security sticker, revealing silver 'VOID' markings when removed.
Step 1: Remove the Atomizer & Surrounding Components. This piece is glued in place, and requires a small amount of force to lift. This can be removed as one whole piece, or disassembled and removed piece by piece. Step 4: Pry the Metal Base Off.
It should lift right out. I just needed to get inside and start probing around with my multimeter. Use a screwdriver set like this one from Amazon to remove the three screws holding the plastic assembly together. Let's assume you don't need a hand in figuring out how to remove the glass from your puffco. My puffco wont heat up, instead it blinks 5 times, on whichever heat setting i have it on. In my case – I did some poking around with a multimeter and determined that my battery was not putting out a high enough voltage. Remove all three screws, and your Puffco will almost fall apart in your hands. Do not force this out. I took it apart and cleaned the whole thing pretty well, i thought that would at least solve the connection issue, but it didnt seem to fix it): any tips or any help will be appreciated! Stay safe friends!!! Step 2: Pry the Shiny Metal Piece Upwards. Checking the voltage supplied to the battery while plugged into USB showed only 4.
keepcovidfree.net, 2024